Treatex Hardwax Oil Oak Medium 2.5L

Preparation:
Various timbers will take colour differently, we strongly recommend a trial application. If the surface to be treated is rough, sand smooth with 80-120 grit sandpaper (no sanding is required between coats). If a previous surface coating finish is present e.g. varnish, lacquer, hard wax oil etc. sand back to bare wood, again using 80-120 grit sandpaper. Most previously oiled surfaces can be overcoated, without sanding. Remove any dust, dirt and make sure the surface to be treated is clean, free of contaminates and thoroughly dry. Surfaces can be cleaned using Treatex Refreshment Cleaner. Stir tins and ensure product is at room temperature before use. We strongly recommend a small trial application. When colouring a previously oiled surface a trial application is essential.

Application:
One coat of Treatex Colour Tone should be brushed or rolled on. To ensure an even colour remove all excess product from the surface with a lint free cloth. Allow to dry - maintaining warmth and ventilation will enable the surface to dry within 3-6 hours. If all excess product is not removed from the surface Colour Tones will not dry properly! Once dry, seal with two coats of Treatex Hardwax Oil Clear Matt, Satin or Gloss.